Warenkorb anzeigen (0 Artikel) Mein KontoMerkzettel anzeigenZur Kasse gehen

Plat-Cat®

Plat-Cat® Platinum Silicone Cure Accelerator is an additive designed to accelerate the cure time of Smooth-On platinum silicone rubber products without significantly affecting the ultimate physical properties. This allows for much faster removal (demold) of a part or rubber mold from the original model. The accelerator is added by weight to Part A and should be thoroughly mixed into Part A before adding Part B. Note: Adding the accelerator drastically reduces the pot life (time you have to mix and pour material) of the liquid rubber product.

  • Plat Cat /450gr

    Beschleuniger für Platin Silikonen, Smooth Sil-Serie, Dragon Skin und der Ecoflex Silikone. Sie brauchen nur wenig Plat Cat für ein gutes Ergebnis.

    71,90 EUR (zzgl. 21% USt. zzgl. Versand)

  • Plat-Cat /2,7kg

    Beschleuniger für Platin Silikonen, Smooth Sil-Serie, Dragon Skin und der Ecoflex Silikone. Sie brauchen nur wenig Plat Cat für ein gutes Ergebnis.

    415,80 EUR (zzgl. 21% USt. zzgl. Versand)

Instructions

Safety - Use in a properly ventilated area (“room size” ventilation). Wear safety glasses, long sleeves and rubber gloves to minimize contamination risk. Store and use material at room temperature (73°F/23°C). This product has a limited shelf life and should be used as soon as possible.

Example - Ecoflex 00-30 (1:1 Mix Ratio): To reduce the demold time of Ecoflex 00-30 from 4 hours to 1 hour, add 40 grams of accelerator to 1000 grams of Ecoflex 00-30 Part A. Mix thoroughly for one minute, making sure that you scrape the sides and bottom of your container several times. Next, add 1000 grams of Part B and mix thoroughly for one minute, again making sure that you scrape the bottom and sides of your container several times. Do not delay between mixing and pouring, as your pot life is about 10 minutes. In about 1 hour, the rubber mold can be removed from the original model.

Example – Smooth Sil 940 (10:1 Mix Ratio): To reduce the demold time of Smooth-Sil 940 from 16 hours to 2.5 hours, add 20 grams ofaccelerator to 1000 grams of Smooth-Sil 940 Part A. Mix thoroughly for one minute, making sure that you scrape the sides and bottom of your container several times. Next, add 100 grams of Part B and mix thoroughly for one minute, again making sure that you scrape the bottom and sides of your container several times. Do not delay between mixing and pouring, as your pot life is about 10 minutes. In about 3 hours, the rubber mold can be removed from the original model.

Hilfe bei der Auswahl

Produkte nach Anwendung sortiert, z. B.:Lifecasting, Bildhauerei, Gießen, Special FX Make-up, Zahnprothesen Special FX, Studium.

Über uns Kontakt Transportoptionen Kundenprojekte Anwendungsbereich Marken Branches

Ihr One-Stop-Shop für 3D-Modelling-Materialien